Items where Subject is "Metallurgy > Magnetic Properties"
Group by: Creators | Item Type Number of items at this level: 32.
BBaskaran, Irusen and Sakthi Kumar, R and Sankara Narayanan, T S N and Stephen, A (2006) Formation of electroless Ni–B coatings using low temperature bath and evaluation of their characteristic properties. Surface and Coatings Technology, 200 (24). pp. 6888-6894. Baskaran, Irusen and Sankara Narayanan, T S N and Stephen, A (2006) Pulsed electrodeposition of nanocrystalline Cu–Ni alloy films and evaluation of their characteristic properties. Materials Letters, 60 (16). pp. 1990-1995. Bhattacharya, S and Mallik, D and Nayar, S (2011) Comparative Study of Biomimetic Iron Oxides Synthesized Using Microwave Induced and Conventional Method. IEEE Transactions on Magnetics, 47 (6). pp. 1647-1653. CChuryukanovaa, Margarita and Kaloshkin, S and Shuvaeva, E and Mitra, A and Panda, A K and Roy , R K and Murugaiyan, Premkumar and Corte-Leon, P and Zhukova, V and Zhukov, A (2019) The effect of heat treatment on magnetic and thermal properties of Finemet-type ribbons and microwires. Journal of Magnetism and Magnetic Materials, 492 (IF-2.683). p. 165598. DDey, S and Roy, R K and Mallick, A B and Mitra, A and Panda, A K (2019) High-temperature magnetocaloric effect in devitrified Fe/Co based glassy monolayer and bilayer ribbons. Journal of Materials Science, 54(16) . pp. 11292-11303. Dey, Sushmita and Roy, Rajat K and Ghosh, M and Mallick, A Basu and Mitra, A and Panda, A K (2017) Enhancement in magnetocaloric properties of NiMnGa alloy through stoichiometric tuned phase transformation and magneto-thermal transitions. Journal of Magnetism and Magnetic Materials, 439 (IF-2.630). pp. 305-311. Dutta, Siuli and Panda, A K and Mitra, Amitava and Chatterjee, S and Roy, Rajat K (2020) Microstructural evolution, recovery and recrystallization kinetics of isothermally annealed ultra low carbon steel. Materials Research Express, 7(1) (IF-1.449). 016554. Dutta, Siuli and Panda, Ashis K and Chatterjee, Subrata and Roy, Rajat K (2020) Effect of annealing treatment on magnetic texture of cold rolled ULC steel. Materials Letters, 276 (IF-3.204). p. 128211. GGoswami, B and Ray, A K (2018) Traditions in hardfacing technology and wear resistance-2. Journal of Metallurgy and Materials Science, 60(2) . pp. 105-124. KKailath, A J and Kumar, Arvind and Mitra, A (2006) Effect of metalloids on crystallization and magnetic behaviour of FeCoSiB based metallic glass. Bulletin of Material Science, 29 (2). pp. 127-131. Krishnan, A A (1951) Permanent magnets and Permanent magnet research. Other (TMP). CSIR-NML, Jamshedpur, Jamshedpur. MMakhija, Dilip and Rath, R K and Mukherjee, A K (2019) Application of enhanced gravity technique for separation of iron phase from LD slag. Metallurgical Research & Technology, 116(3) . Mandal, S and Kailath, A J (2019) Enhanced Plasticity of Cu-Zr-Ti Bulk Metallic Glass and Its Correlation with Fragility. Metallurgical and Materials Transactions A , 50(1) . pp. 199-208. Mishra, A and Dubey, Paritosh and Chandra, R and Srivastava, S K (2021) Observation of large exchange bias field in Mn rich NiMnAl Heusler alloy thin film. Journal of Magnetism and Magnetic Materials, 532 . Murugaiyan, Premkumar and Bedanta, Subhankar and Jena, S K and Panda, A K and Mitra, A and Bysakh, S and Roy, Rajat K (2020) Crystallization and magnetic hardening behaviour of Fe-rich FeSiBNb(Cu) melt-spun alloys. Journal of Magnetism and Magnetic Materials, 502 (IF-2.683). p. 166528. Murugaiyan, Premkumar and Mitra, Amitava and Roy, Rajat K and Bijalwan, P K and Dutta, Monojit and Banerjee, Atanu and Panda, A K (2020) Glass forming ability and soft-magnetic properties of Fe-based glassy alloys developed using high phosphorous pig Iron. Journal of Alloys and Compounds, 821 (IF-4.175). p. 153255. PPal, S K and Manik, N B and Mitra, A (2006) Dependence of frequency and amplitude of the ac current on the GMI properties of Co based amorphous wires. Materials Science and Engineering A, 415 (1-2). pp. 195-201. Prakash, Ved (1971) Development of magnetic materials at the National Metallurgical Laboratory. NML Technical Journal, 13 (3). pp. 69-75. Prakash, Ved and Tewari, C R and Nijhawan, B R (1965) Structure and Magnetic properties of some Alnico Magnet alloys : Effect of cooling rate and tempering treatment. Other (TMP). CSIR-NML, Jamshedpur, Jamshedpur. RRamachandran, E G and Prakash, Ved (1958) The Electrical and Magnetic properties of some low manganese low aluminium steels. Other (TMP). CSIR-NML, Jamshedpur, Jamshedpur. Ramachandran, E G and Prakash, Ved (1958) An Investigation on the Magnetic properties of some permanent magnet materials. Other (TMP). CSIR-NML, Jamshedpur, Jamshedpur. Ranjan, Rajiv and Das, T K and Munda, B N S and Mandal, Eisha (2017) Development of sensor based on GMI effect for structural health monitoring of engineering component. Journal of Metallurgy and Materials Science, 59(1) . pp. 23-27. Roy, R K and Murugaiyan, Premkumar and Panda, A K and Mitra, A (2019) Compositional optimization of high induction (> 1.7T) FeCo-based nanocomposite alloys with enhancement of thermo-physical and magnetic properties. Physica B: Condensed Matter , 566 . pp. 71-76. Roy, Rajat K and Murugaiyan, Premkumar and Bansal, G K and Krishna, K Gopala and Panda, Ashis K (2023) Structural and magnetic behaviors of Fe‑based glassy alloys prepared by industrial raw materials and different processing routes. Journal of Materials Science: Materials in Electronics, 34 (2.8). p. 2218. Roy, Rajat K and Panda, A K and Mitra, Amitava (2016) Effect of Co content on structure and magnetic behaviors of high induction Fe-based amorphous alloys. Journal Of Magnetism And Magnetic Materials, 418 (IF- 2.630). 236-241. SSambamurthy, E and Dutta, Siuli and Panda, A K and Mitra, A and Roy, Rajat K (2014) Evaluation of post-weld heat treatment behavior in modified 9Cre1Mo steel weldment by magnetic Barkhausen emission. International Journal of Pressure Vessels and Piping, 123-124 (IF-1.078). pp. 86-91. Sankara Narayanan, T S N and Selvakumar, S and Stephen, A (2003) Electroless Ni–Co–P ternary alloy deposits: preparation and characteristics. Surface and Coatings Technology, 172 (2-3). pp. 298-307. Sankara Narayanan, T S N and Stephen, A and Guruskanthan, S (2004) Electroless Ni–Co–B ternary alloy deposits: preparation and characteristics. Surface and Coatings Technology, 179 (1). pp. 56-62. Shaw, S K and Sharma, A and Kailashiya, J and Gupta, Santosh K and Meena, Sher Singh and Dash, D and Maiti, P and Prasad, N K (2023) Mesoporous Fe3O4 nanoparticle: A prospective nano heat generator for thermo-therapeutic cancer treatment modality. Journal of Magnetism and Magnetic Materials, 578 . Sinha, P and Chakravarty, S and Singh, R and Singh, P K and Murthy, G V S (2019) Magnetization study of the sensitization in SS304LN. Materials Research Bulletin, 109 . pp. 149-154. Soni, and Mishra, Suman K and Sharma, S K (2019) Influence of nitrogen partial pressure on optical properties of magnetron sputtered Al-Si-N thin films. Thin Solid Films, 682 . pp. 1-9. TTarafder, Mita and Chattoraj, I and Nasipuri, M and Mitra, A (2009) Magnetic characterization of HSLA steel by power-law decay exponents of Barkhausen emission signal. Journal of Magnetism and Magnetic Materials, 321 (8). pp. 1034-1038. |