Items where Subject is "Metallurgy > Metallurgical Techniques > Metallography"

D

Das, Arpan (2012) Phase transformation during tensile and low cycle fatigue deformation of AISI 304LN stainless steel. PhD thesis, Jadavpur University.

Das, Arpan (2017) Resurgence of texture in cyclically deformed austenite. Materials Characterization, 123 (IF 2.714). pp. 315-327.

Das, Goutam (1999) Image analysis in quantitative metallography. In: UNSPECIFIED.

Das, Samar (1999) Metallographic sample preparation techniques. In: UNSPECIFIED.

Dutta, Siuli and Panda, Ashis K and Chatterjee, Subrata and Roy, Rajat K (2020) Effect of annealing treatment on magnetic texture of cold rolled ULC steel. Materials Letters, 276 (IF-3.204). p. 128211.

G

Goswami, B and Ray, A K (2018) Traditions in hardfacing technology and wear resistance-1. Journal of Metallurgy and Materials Science, 60(1) . pp. 25-48.

M

Madge, S V and Louzguine, D V and Lewandowski, J J and Greer , A L (2012) Toughness, extrinsic effects and Poisson’s ratio of bulk metallic glasses. Acta Materialia, 60 . pp. 4800-4809.

R

Rajnikanth, V and Husain, M M and Ray, Ajoy K (2010) Difffusion bonding of non weldable high alloy steel. In: National Welding Meet , August 2010, Puducherry.

Rajnikanth, V and Ray, Ajoy K and Das, Goutam and Ghosh, M and Das, Swapan K and De, P K (2008) Strain Hardening behavior of Al-Sc alloys. Exploratory (OLP). NML, Jamshedpur. (Submitted)

Randhawa, N S and Prasad, Sanjay (2019) Direct Carbothermic Reduction of Weathered Ilmenite for Efficient Removal of Iron by Leaching. Metallurgical and Materials Transactions B, 50(3) . pp. 1277-1289.

S

Satendra, Kumar (2010) Corrosion and fretting corrosion behaviour of surface modified titanium and ti6al4v in simulated body fluid. Masters thesis, Indian Institute of Technology Madras, Chennai.

Sharma, R and Kumar, Sanjeev and Saha, R (2019) A comprehensive survey on selective laser sintering: An additive manufacturing technique. Journal of Metallurgy and Materials Science, 61(1) . pp. 51-60.

Srivastava, V C and Mandal, R K and Ojha, S N (2001) Microstructure and mechanical properties of Al–Si alloys produced by spray forming process. Materials Science and Engineering, 304-306 . pp. 555-558.

T

Tarafder, S (2010) Technology for Engineering Critical Assessment: Project Completion Report. Grant in Aid (GAP). CSIR-NML, Jamshedpur. (Submitted)