Items where Author is "Singh, R K"

Article

Singh, R K and Paswan, S (2024) Isothermal High-Temperature Oxidation Behaviour of Nickel-Based Superalloy IN740H. Transactions of Indian Institute of Metals .

Kumar, C and Jena, P S M and Singh, R K and Harmain, G A and Sahu, J K (2021) Strain ratio effect on microstructural evolution during low cycle fatigue exploitation of nickel base superalloy IN 740H. International Journal of Pressure Vessels and Piping, 194 Part B .

Chalavadi, G and Singh, R K (2021) Feasibility study of iron ore fines beneficiation by shallow bed air fluidized separator. Particulate science and technology, 39(4) (IF-1.619). pp. 391-400.

Chalavadi, G and Singh, R K (2020) Study of Dry Mineral Separation Behavior in Dry Density Separators. Transactions of the Indian Institute of Metals, 73(8) (IF-1.205). pp. 2125-2128.

Pal, C K and Sahu, Ranjan K and Singh, R K and Jena, A K (2019) Magnetically recyclable palladium nanoparticles (Fe3O4-Pd) for oxidative coupling between amides and olefins at room temperature. Applied Organometallic Chemistry, 33(8) .

Singh, R K and Sahu, K K and Chalavadi, G and Singh, Ratnakar and Padmanabhan, N P H (2019) Separation characteristics of centrifugal fluidized separator using binary density system. Mineral Processing and Extractive Metallurgy Review . pp. 1-8.

Singh, R K and Sahu, J K (2019) Influence of hold type and duration on cyclic deformation behaviour of IN740H. Materials Science and Technology, 35(4) . pp. 488-499.

Singh, R K and Sahu, J K (2019) Yield strength anomaly and dynamic strain ageing behaviour of recently developed advanced ultra-supercritical boiler grade wrought Ni-based superalloy IN 740H. Materials at High Temperatures, 36(3) . pp. 220-231.

Jena, P S M and Singh, R K and Mahanta, L and Paswan, S and Sahu, J K (2018) Low cycle fatigue behaviour of nickel base superalloy IN 740H at 760° C: Influence of fireside corrosion atmosphere. International Journal of Fatigue, 116 (IF-3.673). pp. 623-633.

Jena, P S M and Sahu, J K and Rai, R K and Das, S K and Singh, R K (2018) Influence of duplex ferritic-austenitic matrix on two body abrasive wear behaviour of high chromium white cast iron. Wear, 406 (IF-2.531). pp. 140-148.

Chalavadi, G and Singh, R K and Singh, R and Sharma, Mamta and Rath, R K and Mukherjee, A K (2018) Development of Dry Beneficiation Flow Sheet for Fine Coking Coal. International Journal of Coal Preparation and Utilization (IF-1.05). pp. 1-14.

Shekhar, Saurabh and Singh, R K and Chalavadi, G (2018) Study of Process Efficiency for High-Ash Fine Coal Cleaning in a Kelsey Centrifugal Jig. International Journal of Coal Preparation And Utilization, 38(5) (IF-1.527). pp. 250-259.

Shekhar, S and Singh, R K and Chalavadi, G (2016) Study of Process Efficiency for High-Ash Fine Coal Cleaning in a Kelsey Centrifugal Jig. International Journal of Coal Preparation and Utilization (IF-0.673). pp. 1-10.

Arora, Punit and Gupta, S K and Bhasin, V and Singh, R K and Sivaprasad, S and Tarafder, S (2016) Testing and assessment of fatigue life prediction models for Indian PHWRs piping material under multi-axial load cycling. International Journal of Fatigue, 85 (IF-2.899). pp. 98-113.

Chalavadi, G and Singh, R K and Sharma, Mamta and Singh, Ratnakar and Das, Avimanyu (2016) Development of a Generalized Strategy for Dry Beneficiation of Fine Coal over a Vibrating Inclined Deck. International Journal of Coal Preparation and Utilization, 36(1) (IF-0.673). pp. 10-27.

Singh, R K and Sahu, J K and Tarafder, S (2016) Strain rate effect on cyclic deformation behaviour of advanced ultra-super critical boiler grade wrought Ni-based superalloy IN740H at 760 °C. Materials Science and Engineering A, 658 (IF-3.094). pp. 272-279.

Chalavadi, G and Singh, R K and Sharma, Mamta and Das, Avimanyu (2015) Recovery of Combustibles from Fine Coal through Controlled Air Fluidization over Inclined Deck. Separation Science and Technology, 50(13) (IF-1.171). pp. 2032-2040.

Arora, Punit and Gupta, Suneel K and Bhasin, V and Singh, R K and Sivaprasad, S and Tarafder, S (2015) Fatigue studies on Carbon-steel tubes under multiaxial loading. Transactions, SMiRT-23, Manchester, United Kingdom, August 10-14, 2015, Division III (Applied Computation Simulation and Animation) . pp. 1-13.

Jain, Ishant and Singh, R K and Mazumdar, D (2015) Measurements of Some Thermal Properties of Steel-Refractory Systems and Heat Losses from Steelmaking Furnaces. Transactions of the Indian Institute of Metals, 68(3) (IF-0.62). pp. 383-392.

Singh, R K and Misra, S (2013) Corrosion protection of stainless steel in CO2 environment by nanocoating of zinc phosphate with DLC filler. Journal of Metallurgy and Materials Science, 55(2) (Non-SCI). pp. 149-156.

Singh, R K (2012) Corrosion mitigation of stainless steel in milk by aloevera juice. Journal of Metallurgy and Materials Science, 54(1) . pp. 77-85.

Singh, R K and Mehta, K D and Sharma, Mamta and Bhattacharyya, K K (2011) Effect of Magnetic Field Intensity on Iron ore Separation Efficiency in slimes. Journal of Sustainable Planet, 2 (3). pp. 44-49.

Conference or Workshop Item

Rout, Bapin K and Awasthi, S and Choudhary, S K and Singh, R K and Ajmani, S K (2013) Development of Nozzle Clogging Index to Assess The Casting Behavior During Continuous Slab Caster At. In: Proceeding of the International Conference on Science and Technology of Ironmaking and Steelmaking, December 16-18, 2013, CSIR-NML Jamshedpur.

Singh, R K and Mehta, K D and Sharma, Mamta and Bhattacharyya, K K (2011) Performance Evaluation of Magnetic Field Intensity on Iron ore slimes. In: Proceedings of the XII International Seminar on Mineral Processing Technology (MPT-2011), Oct 20-22, 2011, Udaipur, India.

Vidyadhar, A and Srivastava, A and Singh, R K and Nayak, B and Rao, K V and Das, Avimanyu and Bhattacharyya, K K (2011) Development of Processing Technology for Beneficiation of Lean Iron Ore Fines from GOA. In: Proceedings of the XII International Seminar on Mineral Processing Technology (MPT-2011), Oct 20-22, 2011, Udaipur, India.